Program Control - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

6.2

Program control

Operating sequence
Softkey functions
40
5. Press this key to start the recording. The machining of the workpiece is started and graph-
ically displayed on the screen.
1. Select the desired operating area.
2. Switch to "AUTO" mode.
3. Press this softkey to open the lower-level menu for program control.
4. Press the corresponding vertical softkey to activate or deactivate the desired program con-
trol option (see table below for detailed softkey functions). The softkeys selected are high-
lighted in blue.
Disables the output of setpoints to axes and spindles. The setpoint display "simulates" the traverse
movements.
It functions the same as pressing the following key:
After activating this option, the icon "PRT" appears immediately in the program status bar and this
softkey is highlighted in blue.
For more information of the program test, refer to Section "Program test (Page 41)".
All traversing motions are performed with the feedrate setpoint specified via the "Dry run feed"
setting data. Instead of the programmed motion commands, the dry run feed rate is effective.
After activating this option, the icon "DRY" appears immediately in the program status bar and this
softkey is highlighted in blue.
Stops processing of the program at every block in which miscellaneous function M01 is pro-
grammed.
It functions the same as pressing the following key:
After activating this option, the icon "M01" appears immediately in the program status bar and this
softkey is highlighted in blue.
Skips program blocks that are identified with a slash in front of the block number (e.g. "/N100").
After activating this option, the icon "SKP" appears immediately in the program status bar and this
softkey is highlighted in blue.
Available only in the following state:
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015