Cycles; Overview Of Cycles - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

Window display:
①
= $AC_TOTAL_PARTS
②
= $AC_REQUIRED_PARTS
③
=$AC_ACTUAL_PARTS
$AC_SPECIAL_PARTS is not available for display.
④
= $AC_OPERATING_TIME
You can also select whether to activate the workpiece counter function through the following operating area:
→
9

Cycles

9.1

Overview of cycles

Cycles are generally applicable technology subroutines that you can use to carry out a specific machining process, such as
tapping. These cycles are adapted to individual tasks by parameter assignment.
Drilling cycles and turning cycles
You can carry out the following standard cycles by using the control system:
● Drilling cycles
CYCLE81: Drilling, centering
CYCLE82: Drilling, counterboring
CYCLE83: Deep-hole drilling
CYCLE84: Rigid tapping
CYCLE840: Tapping with compensating chuck
CYCLE85: Reaming 1
CYCLE86: Boring
● Turning cycles
CYCLE92: Cut-off
CYCLE93: Recess
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015
→
⑤
= $AC_CYCLE_TIME
⑥
= $AC_CUTTING_TIME
⑦
= $AN_SETUP_TIME
⑧
= $AN_POWERON_TIME
119