Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual page 32

Renumbering blocks
Searching for blocks
Proceed through the following steps to search for a block:
32
3. Select the program file you desire to edit. You can also search for a file or directory by ei-
ther:
Pressing this softkey and specifying the desired criteria in the search dialog. Note that
•
the file extension ".MPF" or ".SPF" must be entered if you desire to search for a program
file. Or,
Entering the first character on the main screen of the program directory. The system
•
directly navigates to the first file starting with that character.
4. Press this key to open the program file. The system switches over to the program editor
window.
5. Edit the blocks in the window as required. Any program changes are automatically stored.
See below for the detailed description of the editing options.
6. After finishing the editing, you can press this softkey to execute the program. The system
switches to the "AUTO" mode in the machining area.
With this softkey, the system automatically assigns block numbers to each block. The block num-
bers are inserted in front of each block in the ascending order in a step of 10.
1. Press this softkey in the opened program editor window.
2. Press this softkey to search via text.
Alternatively, you can search with a given line number by pressing this softkey.
3. Enter the search text or line number in the input field. Press this key to select a starting
point for search if you choose to search via text.
4. Press this softkey to start the search.
Pressing this softkey cancels the search.
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015