Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual page 26
Computer numeric control
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
Measuring the tool in the Z direction
...
26
1.
Select the desired operating area.
2.
Switch to "JOG" mode.
3.
Open the manual tool measurement window.
4.
Press this vertical softkey to measure the tool in the Z direction.
5.
Move the tool to approach the workpiece in the Z direction.
6.
Switch to handwheel control mode.
7.
Select a suitable override feedrate, and then use the handwheel to move the tool to scratch
the required workpiece edge (or the edge of the setting block, if it is used).
8.
Enter the distance between the tool tip and the workpiece edge in the "Z0" field, for exam-
ple, "0". (This value is the thickness of a setting block if it is used.)
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015
Hide quick links:
Advertisement
Table of Contents
