Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual page 232

232
4. Press this softkey to open the contour editor.
5. Define a start point with the following parameters and press this softkey to confirm.
Programming mode: DIAMON
•
Z: 0
•
X: 0
•
6. Press this softkey to select a contour element of straight vertical line.
7. Enter the parameters for this element and press this softkey to confirm.
X: 48 abs.
•
CHR: 3
•
8. Press this softkey to select a contour element of straight horizontal line.
9. Enter the parameters for this element and press this softkey to confirm.
RND: 4
•
10. Press this softkey to select a contour element of circular arc.
11. Enter the parameters for this element and press this softkey to select the desired contour
characteristics.
R: 23
•
X: 60 abs.
•
Z: -20 abs.
•
12. Press this softkey to confirm.
13. Press this softkey to select a contour element of straight horizontal line.
14. Enter the parameters for this element and press this softkey to confirm.
Z: -75 abs.
•
RND: 6
•
15. Press this softkey to select a contour element of straight line in any direction.
16. Enter the parameters for this element and press this softkey to confirm.
X: 90 abs.
•
Z: -80 abs.
•
RND: 4
•
17. Press this softkey to select a contour element of straight horizontal line.
18. Enter the parameters for this element and press this softkey to confirm.
Z: -100 abs.
•
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015