Setting User Interface Language - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

Protection level 7
Protection level 7 is set automatically if no password is set and no protection level interface signal is set. The protection level
7 can be set from the PLC user program by setting the bits in the user interface.
In the menus listed below the input and modification of data depends on the set protection level:
● Tool offsets
● Work offsets
● Setting data
● Program creation/program correction
The number of machine data and drive data which can be read or modified depends on the protection level. You can set the
protection level for these function areas with the display machine data (USER_CLASS...).
Setting password
You can set the desired password through the following operating area:
+
2.5

Setting user interface language

Operating sequence
+
14
→
1. Select the desired operating area.
2. Press this softkey to open the user interface language selection window.
3. Use the cursor keys to select the desired language.
4. Press this softkey to confirm your selection.
Note:
The HMI (Human Machine Interface) is automatically restarted when a new language is
selected.
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015