A.14.7
Cycle support
Functionality
The following technologies are provided with additional support in the form of pre-defined cycles, which then must be
parameterized.
● Drilling
● Turning
For more information, see Chapter "Cycles (Page 119)".
A.14.8
Programming example for turning application
Example 1
The following diagram shows a programming example for the "Free contour programming" function.
Operating sequence:
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015
1.
Select the desired operating area.
2.
Enter the desired program folder.
3.
Select a program with cursor keys and press the following key to open the program in the
program editor.
4.
Press this softkey to open the contour editor.
229