Entering/Modifying The Tool Wear Data - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

For the explanation of other softkeys in this mode, see Section "Other settings in "JOG" mode (Page 202)".
For the explanation of part programming in "MDA" mode, see Section "Notes on part programs in "MDA" mode (Page 207)".
4.2.7

Entering/modifying the tool wear data

Note
You must distinguish the direction of tool wear compensation clearly.
Operating sequence
28
To display additional G functions, use the corresponding keys.
This window displays the auxiliary and M functions currently active. To close the window, press this
softkey once again.
This softkey opens the file saving window where you can specify a name and a storage medium for
the program displayed in the MDA window. To save your program, either enter a new program
name in the input field or select an existing program for overwriting.
Note:
If you do not save with this softkey, the program edited in "MDA" mode is actually a temporary file.
Pressing this softkey deletes all the blocks displayed in the MDA window.
This softkey opens a window where you can select an existing program file from a system directory
to load into the MDA buffer.
1. Select the desired operating area.
2. Open the tool wear window.
3. Use the cursor keys to select the required tools and their edges.
4. Enter the tool length wear parameter of axis X and axis Z as well as the tool radius wear
parameter.
Positive value: The tool moves away from the workpiece.
Negative value: The tool moves closer to the workpiece.
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015