Simultaneous Recording Prior To Machining Of The Workpiece; Simultaneous Recording During Machining Of The Workpiece - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

6.1.2

Simultaneous recording prior to machining of the workpiece

Before machining the workpiece on the machine, you can graphically display the execution of the program on the screen to
monitor the result of the programming.
Operating sequence
For more information about the softkeys in the simultaneous recording window, see Section "Simulation prior to machining of
the workpiece (Page 37)".
6.1.3

Simultaneous recording during machining of the workpiece

You can follow machining of the workpiece on the screen while the program is being executed on the machine. If the view of
the work space is blocked by coolant, for example, while the workpiece is being machined, you can also track the program
execution on the screen.
Operating sequence
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015
1. Select the desired operating area.
2. Select a part program for simulation.
3. Press this softkey and the system automatically changes to "AUTO" mode in the machining
operating area.
4. Press this softkey to open the lower-level menu for program control.
5. Press these softkeys respectively to activate the PRT mode and the feedrate settings for the
dry run.
6. Press this softkey to open the simultaneous recording window.
7. Press this key to start the recording. The program execution is displayed graphically on the
screen.
1. Select the desired operating area.
2. Select a part program for simulation.
3. Press this softkey and the system automatically changes to "AUTO" mode in the machining
operating area.
4. Press this softkey to open the simultaneous recording window.
39