Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual page 89

Example 2: Spindle positioning in axis mode
Program variant 1:
N10 G0 X100 Z100
N20 M3 S500
N30 G0 X80 Z80
N40 G01 X60 Z60 F0.25
N50 SPOS=0
N60 X50 C180
N70 Z20 SPOS=90
N80 M30
Program variant 2:
N10 G0 X100 Z100
N20 M3 S500
N30 G0 X80 Z80
N40 G01 X60 Z60 F0.25
N50 M2=70
N60 X50 C180
N70 Z20 SPOS=90
N80 M30
Example 3: Drill cross holes in turned part
Cross holes are to be drilled in this turned part. The running spindle is stopped at zero degrees and then successively turned
through 90°, stopped and so on.
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015
Position control on, spindle 1 positioned to 0, axis mode can be
used in the next block.
Spindle(C axis) is traversed with linear interpolation synchronous
to X.
Spindle is positioned to 90 degrees.
Spindle switches to axis mode.
Spindle(C axis) is traversed with linear interpolation synchronous
to X.
Spindle is positioned to 90 degrees.
89