Thread Chaining - Cycle98 - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

N10 D3 T1 S300 M3 G95 F0.3
N20 G0 G90 Z100 X50
N30 CYCLE96 (42, 60, "A",)
N40 G90 G0 X100 Z100
N50 M2
9.5.7

Thread chaining - CYCLE98

Programming
CYCLE98 (PO1, DM1, PO2, DM2, PO3, DM3, PO4, DM4, APP, ROP, TDEP, FAL, IANG, NSP, NRC, NID, PP1, PP2, PP3,
VARI, NUMTH, _VRT)
Parameters
Parameter Data type
PO1 REAL
DM1 REAL
PO2 REAL
DM2 REAL
PO3 REAL
DM3 REAL
PO4 REAL
DM4 REAL
APP REAL
ROP REAL
TDEP REAL
FAL REAL
IANG REAL
NSP REAL
NRC INT
NID INT
PP1 REAL
176
Description
Thread starting point in the longitudinal axis
Thread diameter at the starting point
First intermediate point in the longitudinal axis
Diameter at the first intermediate point
Second intermediate point
Diameter at the second intermediate point
Thread end point in the longitudinal axis
Diameter at the end point
Run-in path (enter without sign)
Run-out path (enter without sign)
Thread depth (enter without sign)
Finishing allowance (enter without sign)
Infeed angle
Range of values:
>0: Infeed along the rear flank
<0: Infeed along the front flank
=0: Infeed at a right angle to the cutting direction
Starting point offset for the first thread turn (enter without sign)
Number of roughing cuts (enter without sign)
Number of idle passes (enter without sign)
Thread lead 1 as a value (enter without sign)
; Specification of technology values
; Selection of starting position
; Cycle call
; Approach next position
; End of program
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015