Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual page 238

Address Significance
G331 Thread interpolation
G332 Thread interpolation - retraction
G4 Dwell time
G74 Reference point approach
G75 Fixed point approach
TRANS Translation, programmable
SCALE Programmable scaling factor
ROT Rotation, programmable
MIRROR Programmable mirroring
ATRANS Additive translation, programming
ASCALE Additive programmable scaling factor
AROT Additive programmable rotation
AMIRROR Additive programmable mirroring
G17 X/Y plane (when center-drilling,
TRANSMIT milling required))
G18 * Z/X plane (standard turning)
G19 Y/Z plane
238
Value assign- Information
ments
2: Special motions, dwell time,
non-modal
3: Write memory, non-modal
6: Plane selection
Programming
N10 SPOS=... ; Spindle in
position control
N20 G331 Z... K... S...
;tapping without compen-
sating chuck e.g. in Z axis
;RH or LH thread is de-
fined via the sign of the
lead (e.g. K+):
+ : as with M3
- : as with M4
G332 Z... K... ;tapping
without compensating
chuck, e.g. in Z axis,
retraction motion
; sign of lead as for G331
G4 F...;separate block, F:
Time in seconds
or
G4 S.... ;separate block,
S: in spindle revolutions
G74 X=0 Z=0 ;separate
block,
(machine axis identifier!)
G75 X=0 Z=0 ;separate
block,
(machine axis identifier!)
TRANS X... Z... ;separate
block
SCALE X... Z... ; scaling
factor in the direction of
the specified axis, sepa-
rate block
ROT RPL=... ;rotation in
the current plane G17 to
G19, separate block
MIRROR X0 ; mirror the
coordinate axis, separate
block
ATRANS X... Z... ; sepa-
rate block
ASCALE X... Z... ; scaling
factor in the direction of
the specified axis, sepa-
rate block
AROT RPL=... ; rotation
in the current plane G17
to G19, separate block
AMIRROR X0 ;mirror the
coordinate axis, separate
block
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015