Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual page 19

Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015
5. Enter the tool number (value range: 1 to 31999; preferentially enter a value less than 100)
and select the corresponding tool edge position code according to the actual tool point di-
rection in the following windows:
Available edge positions for turning tool and grooving tool: 1, 2, 3 and 4 (taking new
•
turning tool as an example)
Available edge positions for drilling tool, tapping tool and milling tool: 5, 6, 7 and 8
•
(taking new milling tool as an example)
6. Use this softkey to confirm your settings. The window below shows the information of the
new tool created.
①
Tool type
②
Tool number
③
Tool offset number
④
Tool offset number
⑤
Tool length in the X and Z axes
⑥
Tool radius
⑦
Clearance angle
⑧
Tip width of the cutting edge, which is only active for the grooving tool
⑨
Cutting edge direction
19