Setting The Relative Coordinate System (Rel); Setting The Jog Data - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

A.6.1

Setting the relative coordinate system (REL)

Operating sequence
A.6.2

Setting the JOG data

Operating sequence
204
1. Select the desired operating area.
2. Switch to "JOG" mode.
3. Press this softkey to switch the display to the relative coordinate system.
4. Use the cursor keys to select the input field, and then enter the new position value of the
reference point in the relative coordinate system.
5. Use this key to activate the values after each entry.
You can use the corresponding vertical softkeys to set the reference point to zero.
Set the X axis to zero
Set the Z axis to zero
Set the spindle to zero
Set all axes to zero
1. Select the desired operating area.
2. Switch to "JOG" mode.
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015