Insufficient Paper For Job; This Paper Cannot Be Used As Size Is Not Supported - Canon imagePROGRAF iPF8400 User Manual

iPF8400
Because the Platen is soiled with ink or other substances, the size of the clear film cannot
be detected.

Insufficient paper for job

Insufficient paper for job
The printer has received a print job longer than the amount of roll paper left when Man-
ageRemainRoll in the Control Panel menu is On.

This paper cannot be used as size is not supported.

This paper cannot be used as size is not supported.
Cause
Paper that is too large for the printer has been loaded.
Paper that is too small for the printer has been loaded.
User's Guide
Cause
Cause
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.")
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.")
Corrective Action
If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push the
roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.
(See "Attaching the Roll Holder to Rolls.")
→
P.536
Open the Top Cover and clean the entire Plat-
en.
(See "Cleaning Inside the Top Cover.")
→
P.943
Corrective Action
Press ▲ or ▼ to select Print, and then press the OK
button to resume printing.
When using the Media Take-up Unit, press ▲ or ▼
to select Print, and then press the OK button to re-
sume printing.
However, the roll paper may run out during the print
job and you may not be able to print all of the docu-
ment.
Press ▲ or ▼ to select Change Paper, and then
press the OK button.
Change the Paper Source of the printer driver, or re-
place the roll with a roll that has enough paper for
the print job, and then printt.
When using the Media Take-up Unit, press ▲ or ▼
to select Stop Printing, and then press the OK but-
ton to stop printing.
Remove the printed document from the Media Take-
up Unit, replace the roll with a roll that has enough
paper for the print job, and then try printing again.
(See "Removing the Roll from the Printer.")
(See "Loading Rolls in the Printer.")
(See "Removing Printed Documents from the Media
Take-up Unit (Optional).")
Press ▲ or ▼ to select Stop Printing or press the
Stop button to stop printing.
Corrective Action
→
P.528
→
P.528
Insufficient paper for job
→
P.545
→
P.539
→
P.586
995