Insufficient Paper For Job; This Paper Cannot Be Used As Size Is Not Supported; Roll Printing Is Selected - Canon imagePROGRAF iPF9400S Basic Manual

Insufficient paper for job

Because the Platen is soiled with ink or other substances, the size of the clear film
cannot be detected.
Insufficient paper for job Insufficient paper for job
The printer has received a print job longer than the amount of roll paper left when ManageRe-
mainRoll in the Control Panel menu is On.

This paper cannot be used as size is not supported.

This paper cannot be used as size is not supported.
Paper that is too large for the printer has been loa-
ded.
Paper that is too small for the printer has been loa-
ded.
Paper has been loaded that is too small to print the
test pattern for printhead adjustment or nozzle
checking.

Roll printing is selected.

Roll printing is selected.
You have attempted to print on a roll, but no
132
roll is loaded.
Cause
Cause
Cause
Cause
Press ▲ or ▼ to select Load Roll Paper, and then press the OK button. Load the roll, and
then print.
(See "Attaching the Roll Holder to Rolls.")
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.")
→User's Guide
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.") →User's Guide
Lift the Release Lever and load unused paper A4/Letter (vertical) or larger. More
than one sheet may be required depending on the adjustment.
Corrective Action
Corrective Action
Open the Top Cover and clean the entire
Platen.
(See "Cleaning Inside the Top Cover.")
→P.53
Corrective Action
Press ▲ or ▼ to select Print, and then
press the OK button to resume printing.
When using the Media Take-up Unit,
press ▲ or ▼ to select Print, and then
press the OK button to resume printing.
However, the roll paper may run out
during the print job and you may not be
able to print all of the document.
Press ▲ or ▼ to select Change Paper,
and then press the OK button.
Change the Paper Source of the printer
driver, or replace the roll with a roll that
has enough paper for the print job, and
then printt.
When using the Media Take-up Unit,
press ▲ or ▼ to select Stop Printing,
and then press the OK button to stop
printing.
Remove the printed document from the
Media Take-up Unit, replace the roll
with a roll that has enough paper for the
print job, and then try printing again.
(See "Removing the Roll from the Print-
er.")
→P.15
(See "Loading Rolls in the Printer.")
→P.11
(See "Removing Printed Documents
from the Media Take-up Unit (Optional).")
→User's Guide
Press ▲ or ▼ to select Stop Printing
or press the Stop button to stop print-
ing.
Corrective Action
→P.9
iPF9400S
Basic Guide