Repair; Replacing A Defective Fuse - Otto Bock 9B500-S CLASSIC Instructions For Use Manual

Maintenance/Repair

7.3 Repair

7.3.1 Replacing a defective fuse

INFORMATION
When replacing, only use fuses of the same type. Note the
rating printed on it.Note the rating printed on it.
The safety fuse (for values, see section "Technical data" >
table "Electrical system") is located in the battery drawer
(power wheelchair with drive wheel suspension) or in a bat­
tery tray (power wheelchair without drive wheel suspension).
Opening the battery drawer (in models with drive wheel
suspension)
> The control unit is turned off.
1) Pull up the release bolt.
2) Pull gently on the battery drawer to roll it out to the rear.
3) Open the clip on the strap.
4) Remove the battery drawer cover.
68 | Ottobock
Fig. 43 Pulling on the release bolt
Opening the battery tray (on models without drive
wheel suspension)
The control unit is turned off.
>
1) Lift the seat cushion from the seat plate.
2) Remove the seat bottom.
3) Open the clip on the battery tray strap.
4) Remove the battery tray cover.
B500-S classic