Fuse; Status And Error Analysis - Otto Bock A 200 Instructions For Use Manual

Attention!
Regularly checking of the remaining battery capacity and charging of the battery early enough are
indispensable preconditions for the operational safety of your power wheelchair.
Figure 18

10.9 Fuse

The two 60 A fuses are located at the rear end of the battery packs between the battery's contacts (Fig. 19).

11 Status and Error Analysis

The following table lists the different error and status messages of the battery indicator and describes the cor-
responding possible causes and solutions. This offers the possibility for yourself to identify and eliminate errors
of the A200. If you do not manage to solve the problem, please contact your dealer.
Indicator
Battery indicator flashes slowly
More and more LEDs of the battery
indicator begin to flash
Battery indicator flashes once every
every 2.5 seconds
Battery indicator flashes quickly
Fast flashing of LED 1 (red)
Fast flashing of LEDs 1-2
Fast flashing of LEDs 1-3
Fast flashing of LEDs 1-4
Fast flashing of LEDs 1-5
Fast flashing of LEDs 1-6
Figure 19
Cause
Battery is empty
Battery charger is connected,
A200 not ready for driving
Sleeping mode after longer time
of standstill with the wheelchair
control switched on
Safety-relevant problem,
driving function switched off
Battery empty or poor
connection to the battery
Poor connection
to the left motor
Short circuit on the left motor
Poor connection
to the right motor
Short circuit on the right motor
Influence by an external signal
(e.g. charging plug)
Possible solution
Charge as soon as possible
Disconnect the battery charger,
switch off and on
Switch off and on
Switch off and on
check plug connections
and that battery voltage is ok
Charge the battery or check
the plug connections
Check the motor plug connection
Check the motor plug connection
Check the motor plug connection
Check the motor plug connection
Remove the charging plug
33