POSITIONING THE VEHICLE ON
THE REAR SUPPORT STAND
Loosen the knob (1).
◆
Withdraw the fork support (2) and extract
◆
it from the stand seat.
Insert the support pin (3).
◆
Repeat the previous operations on the
◆
opposite side of the stand.
WARNING
Raise the vehicle by means of the two
rear fork arms only.
Insert the stand from the back of the
◆
vehicle and position it so that the two
support pins (3) can be housed as
follows:
√ the right support between brake caliper
and brake pipe coupling on the rear fork
(Pos. A);
√ the left support between gearwheel and
chain (Pos. B).
Withdraw the support pins (3) and make
◆
them hit against the rear fork.
Tighten the two knobs (1).
◆
NOTE
Have someone help you keep the
vehicle in vertical position with the two
wheels on the ground.
Rest one foot on the rear part of the
◆
stand (4).
Push the stand (4) downwards until it
◆
reaches the end of its stroke (see figure).
4
use and maintenance RS 50 Tuono
43