Rear Wheel - APRILIA Pegaso 650 Use And Maintenance

2%!2 7(%%,
a
The disassembly and reassem-
bly of the rear wheel may be diffi-
cult for unskilled operators. If
necessary, contact an APRILIA Official
Dealer.
If you want to perform these operations
personally, keep to the following in-
structions.
Carefully read p. 36 (MAINTENANCE).
Before carrying out the following opera-
tions, let the engine and the silencer
cool down until they reach room tem-
perature, in order to avoid burns.
44 use and maintenance Pegaso 650
a
While disassembling and reas-
sembling the wheel, be careful
not to damage the brake pipe,
the disc and the pads.
DISASSEMBLY
U
Position the vehicle on the stand, see
p. 35 (POSITIONING THE VEHICLE ON
THE STAND).
U
Unscrew and remove the four screws (1).
U
Remove the oil pan guard (2).
a
Due to the weight and dimen-
sions of the vehicle, the follow-
ing operation cannot be per-
formed by one person only.
Proceed with care and make sure that
you can support the weight of the vehi-
cle.
c
Weight of the vehicle without
driver (ready for starting): 200 kg.
U
Raise the rear part of the vehicle, have a
suitable support (the height of which
should be 350 mm) placed under the en-
gine, so that the rear wheel can rotate
freely and the vehicle cannot fall down.
a
The vehicle may fall down.
Provide for balancing the vehi-
cle, in order to prevent it from
falling down.
Make sure that the vehicle is stable.
U
Lock the wheel pin (3) rotation, by
means of the suitable spanner.
U
Unscrew and remove the nut (4) and
take the washer (5).
Wheel nut driving torque:
100 Nm (10 kgm).
c
To facilitate the extraction of the
wheel pin, slightly raise the
wheel.