'61HN252' by American Honda Motor Co. - Page 355 of 540
[2005-2008] [TRX500 FA/FGA]
FRONT DRIVE SHAFT
1 of 1
REMOVAL
Remove the front wheel
(page 14-12).
Remove the cotter pin and loosen the axle nut.
Remove the cotter pin.
Remove the tie-rod ball joint nut while holding the
joint stud flats with an open end wrench.
Remove the tie-rod from the knuckle.
Remove the two bolts and splash guard.
Remove the cotter pins and loosen the castle nuts of
the suspension arm ball joints, but do not remove
them yet.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
FRONT DRIVING MECHANISM
AXLE NUT
TIE-ROD
BALL JOINT NUT
SPLASH GUARD
COTTER PINS
COTTER PIN
COTTER PIN
BOLTS
NUT
17-7
3/9/2008 11:13 PM