Ford 2002 Bantam Workshop Manual page 1645

501-20B-54
REMOVAL AND INSTALLATION (CONTINUED)
08/2001
Occupant Restraints — Passive — Supplemental Air
Bag System
5. Remove the air bag sliding contact.
Installation
1. Install the air bag sliding contact.
1. Connect the electrical connectors.
2. Check the retaining tangs have engaged.
2. WARNING: The sliding contact
centralizing procedure MUST be
carried out before installing the
sliding contact.
WARNING: If there is any doubt about
the centralization of the air bag sliding
contact. The centralization procedure
must be repeated.
Centralize the clockspring.
1. Depress the locking pin.
2. Rotate the inner rotor against the outer
rotor fully counter clockwise.
3. Rotate the inner rotor clockwise
approximately 3.75 turns. Release the
locking pin. Make sure the inner rotor is
locked in position.
3. Refit the steering wheel. For additional
information,
501-20B-54
refer to Section 211-04.
2002 Bantam