Before You Begin; Safety Summary; Safety Icons - Intermec EasyCoder PX4i Service Manual

Before You Begin

Safety Summary

Safety Icons

EasyCoder PX4i and PX6i Service Manual
Downloaded from www.Manualslib.com
This section provides you with safety information, technical support infor-
mation, and sources for additional product information.
Your safety is extremely important. Read and follow all warnings and cau-
tions in this document before handling and operating Intermec equipment.
You can be seriously injured, and equipment and data can be damaged if
you do not follow the safety warnings and cautions.
Do not repair or adjust alone
Do not repair or adjust energized equipment alone under any circum-
stances. Someone capable of providing fi rst aid must always be present for
your safety.
First aid
Always obtain fi rst aid or medical attention immediately after an injury.
Never neglect an injury, no matter how slight it seems.
Resuscitation
Begin resuscitation immediately if someone is injured and stops breath-
ing. Any delay could result in death. To work on or near high voltage, you
should be familiar with approved industrial fi rst aid methods.
Energized equipment
Never work on energized equipment unless authorized by a responsible
authority. Energized electrical equipment is dangerous. Electrical shock
from energized equipment can cause death. If you must perform autho-
rized emergency work on energized equipment, be sure that you comply
strictly with approved safety regulations.
This section explains how to identify and understand dangers, warnings,
cautions, and notes that are in this document. You may also see icons that
tell you when to follow ESD procedures.
A warning alerts you of an operating procedure, practice, condition, or
statement that must be strictly observed to avoid death or serious injury
to the persons working on the equipment.
A caution alerts you to an operating procedure, practice, condition, or
statement that must be strictly observed to prevent equipment damage
or destruction, or corruption or loss of data.
This icon appears at the beginning of any procedure in this manual
that could cause you to touch components (such as printed circuit
boards) that are susceptible to damage from electrostatic discharge
(ESD). When you see this icon, you must follow standard ESD guide-
lines to avoid damaging the equipment you are servicing.
Note: Notes either provide extra information about a topic or contain spe-
cial instructions for handling a particular condition or set of circumstances.
manuals search engine
Before You Begin
vii