Intermec EasyCoder PX4i Service Manual page 114

Chapter 8 — Print Unit
104
Downloaded from www.Manualslib.com
IPL only
In IPL, the media feed is affected by the mode of operation. There are
three such modes:
• Tear-off (straight-through)
(default)
• Peel-off (self-strip)
(enabled/disabled by <STX><SI>Tn<ETX> command)
• Cut-off
(activated/deactivated when the cutter is enabled/disabled in the Setup
Mode or by <STX><SI>Cn<ETX> command)
Each mode has a fi xed amount of media feed, which can be fi ne-adjusted
using the Label Rest Point parameter in the Setup Mode (See Appendix A,
Setup/Media/Lbl Rest Point) or an <STX><SI>fn<ETX> command.
The type of detection is decided by the Media Type parameter in the Setup
Mode (See Appendix A, Setup→Media→Media Type).
manuals search engine
EasyCoder PX4i and PX6i Service Manual