Spring Replacement - Intermec EasyCoder PX4i Service Manual

Chapter 11 — Paper Cutter

11.6 Spring Replacement

124
Downloaded from www.Manualslib.com
The spring that presses the anvil blade against the rotating shear may
eventually get slack, especially if the anvil blade is forced open, for example
during cleaning. A slack spring must be replaced as follows:
• Remove the right-hand gable of the cutter (two #T20 Torx screws).
• Remove the right-hand gable of the cutter mechanism (two #T20 Torx
screws + three Posidrive screws).
• Replace the spring and assemble in reverse order, making sure to put
back all the washers.
manuals search engine
EasyCoder PX4i and PX6i Service Manual