C Fold Position Adjustment - Fuji Xerox ApeosPort-V C5580 Administrator's Manual

14
Select the tray in which you loaded paper, select [Book Fold State (15 Sheets)], and press
the <Start> button.
The sample printout is printed.
15
Select [Save].
16
Confirm the result of sample printout.
17
Adjust the alignment again if necessary.
18
Select [Save].
19
Select [Close] until the Services Home screen is displayed.
Note • When you configure settings under [System Settings] or [Setup] and then press the <Services Home>

C Fold Position Adjustment

1
Select [C Fold - A4] or [C Fold - 8.5x11"], and
then select [Change Settings].
2
Select [Sample Printout].
3
Select the tray in which you loaded paper, and
press the <Start> button.
A sample printout is printed.
4
Select [Close].
5
Check the sample printout, measuring the A and B fold position movement amounts.
6
Enter the values you measured in step 5 in [Values A & B Before Adjustment], and the value
to which to adjust in [Desired Values A & B].
Important • Set value A and value B so that an edge of the paper does not extend beyond a fold position of the
button, the screen directly goes back to the Services Home screen.
paper. Extending an edge of paper beyond a fold position of the paper may cause a paper jam.
Fold Position Adjustment
619
16