Fold Position Adjustment - Fuji Xerox ApeosPort-V C5580 Administrator's Manual

16 Appendix

Fold Position Adjustment

This section describes how to adjust the fold position.
You can adjust the fold position for each paper type, and save 10 types of adjusted values.
You can assign a set type to each tray.
You can adjust the fold position for single fold, booklet, C fold, Z fold, Z fold half sheet.
Fold Position Adjustment
1
Load the paper to adjust the fold position in the tray.
2
Press the <Log In/Out> button, and enter the System Administration mode
For more information on how to enter the System Administration mode, refer to "System Settings Procedure" (P.118).
3
Select [Tools] on the Services Home screen.
4
Select [System Settings] > [Common Service Settings] > [Maintenance].
5
Select [Finisher Adjustment].
6
Select [Adjust Fold Position].
7
Select [Fold Position Type Setup], and then
select [Change Settings].
8
Select [Name], and select [Change Settings].
9
Enter the type name, and select [Save].
16
10
Enter the type name, and select [Save].
Note
11
Select the fold type, and then select [Change Settings].
For more information on each fold adjustment, refer to the following sections.
616
• We recommend you to use a name such as "Single Fold Plain" that allows you to know what the
content is.
-For single fold, refer to "Single Fold Position Adjustment" (P.617).
-For booklet, refer to "Booklet Position Adjustment" (P.618).