Output Size Defaults; Reduce/Enlarge Presets; Other Settings - Fuji Xerox ApeosPort-V C5580 Administrator's Manual

Output Size Defaults

Set the sizes to display in [Output Size] when selecting [Enter Output Size] for scanning
documents at [Reduce/Enlarge] in the [Layout Adjustment] screen.
You can assign any output size to output size buttons. Assigning the output sizes to the
buttons will save your time to specify the size each time.
 A/B Series Size
You can select a size from A and B series sizes such as A4 and B5.
 Inch Size
You can select a size from Inch series sizes such as 8.5 x 11" and 11 x 17".
 Others
You can select a size from other sizes such as photo and postcard.

Reduce/Enlarge Presets

Set the magnifications displayed as [Preset %] which are displayed when [Proportional %]
is selected under [Reduce/Enlarge] in the [Layout Adjustment] screen.
You can assign any magnification to the Reduce/Enlarge Preset buttons other than [100%].
 Preset %
Select a ratio from standard magnification ratios.
 Variable %
You can specify a magnification from 25 to 400% in 1% increments.

Other Settings

You can configure other settings related to the Scan services specifications.
Memory Full Procedure
If there is insufficient hard disk memory while scanning a document, a screen appears
asking you how you want to handle the partially stored data.
Set the process you want the machine to perform for the partially stored data after a certain
time has elapsed in the confirmation screen.
You can set the time until the memory full procedure is carried out. For more information, refer to "Auto Job Release" (P.138).
 Delete Job
Deletes the data partially stored.
 Run Job
Treats the read-in data as valid, and starts sending the document partially stored.
Maximum Stored Pages
Set the maximum number of pages stored for a scan document. You can specify from 1 to
999 pages.
Scan Service Settings
5
229