Starting Setup Utility - NEC EXPRESS 5800 User Manual

3-2 Configuring Your System

Starting SETUP Utility

Powering on the server starts POST (Power On Self-Test) and displays its check results. If the
NEC logo is displayed, press Esc.
After a few seconds, the following message appears at bottom left on the screen.
Press <F2> to enter SETUP
Press F2 to start the SETUP utility and display its Main menu.
If you have previously set a password with the SETUP utility, the password entry screen appears.
Enter the password.
Enter password:[
Up to three password entries will be accepted. If you fail to enter the password correctly for three
consecutive times, the server halts. (You can no longer proceed.) Power off the server.
The server is provided with two levels of password: Administrator
NOTE:
and User. With the Administrator password, you can view and change all
system parameters. With the User password, system parameters available
for viewing and changing are limited.
]