NEC EXPRESS 5800 User Manual page 219

Windows 2000 started with different display resolution from the specified value.
If the specified display resolution can not be used, the system will use the nearest value
!
or the default value of the driver.
Entered the incorrect Product ID/CD key.
Even if you entered the incorrect Product ID/CD key, Express Setup will start. However,
!
the setup will stop and asks you to re-enter the correct value. Also in this case, input
request will occur when rebooting after GUI setup completed during Express Setup. If
these 2 inputs are done correctly, there is no problem on Windows 2000 setup.
Unable to specify the details of Network adapter.
In Express Setup, you can not specify the details of Network adapter. Specify them from
!
Control Panel after starting Windows 2000.
Windows 2000 is started with Network adapter that has not been specified during Express Setup
Windows 2000 will install the recognized Network adapter specified as default value. If
!
you want to modify the specification, it can be done from Control Panel after starting
Windows 2000. Also, the Network adapter that has been specified during Express Setup
but that is not connected will not be setup, though the protocol will only be installed.
Connected more than two Network adapter and specified different protocol for each adapter, but all the
protocols are specified on either adapter.
It's a design. Each adapter is specified so that all the installed protocols can be used.
!
The value that can not be specified during Express Setup will all be specified by default
value.
When more than two Network adapter are specified, the detailed specification of TCP/IP protocol are all set to
use DHCP.
When more than two Network adapter are specified, the detailed specification of the
!
protocol may all be set by default value. Re-specify the details from Control Panel.
Troubleshooting 6-23