NEC EXPRESS 5800 User Manual page 244

7-6 Upgrading Your System
Installation
Perform the following steps to install a hard disk drive.
NOTE: Any hard disk can be installed or removed from the server by
only removing the front bezel of the server
IMPORTANT: In the disk array configuration, use the hard disks having
the same specification including the capacity.
1. Prepare your system for upgrade. See "Preparing for Installation and Removal" described
earlier in this chapter.
Unlock the front bezel with the security key and remove the front bezel.
2.
Locate the slot in which you are going to install a hard disk drive.
3.
The server has three slots. Install hard disk drives in ascending order of the SCSI ID
numbers starting from the leftmost slot (SCSI ID0).
4. Remove the dummy tray. The dummy tray is released by pressing down on the lock
button inside the top of the tray handle, pulling the tray handle towards you, and pulling
the tray out of the bay.
IMPORTANT:
effect. Always leave the dummy tray in unused bays so that the server can
operate efficiently. Save the dummy tray for future use.
The dummy tray is provided to maintain the proper cooling