NEC EXPRESS 5800 User Manual page 137

Installing Windows 2000
This section describes how to setup the system using Express Setup.
Prepare the Configuration Diskette. You can perform the installation without a Configuration
Diskette specified in advance, but one floppy disk formatted by MS-DOS 1.44MB will be
required.
IMPORTANT:
If you modified the system configuration, execute "System Update".
!
If you want to modify or add Graphic Accelerator Driver or the
!
drivers of Network Adapter and so on, see Appendix C.
Turn the power of peripheral devices on, and then turn on the server.
1.
Insert the EXPRESSBUILDER CD into the CD-ROM drive of the server.
2.
Press the RESET switch or press Ctrl, Alt, and Delete to reboot the
3.
EXPRESSBUILDER. (You may also turn power off and then on again to reboot the
server.)
The system will boot from the CD-ROM and EXPRESSBUILDER starts.
The "Language Selection Menu" is displayed. Select the language and keyboard to be
4.
used to perform Express Setup.
Click [Express Setup].
5.
"Note" will be displayed.
Read the instruction carefully and click [OK].
6.
The message "Insert Configuration Diskette" appears.
Insert "Configuration Diskette" into floppy disk drive and click [OK].
7.
NOTE: If you do not have a pre-specified configuration "Configuration
Diskette", insert a blank 1.44MB formatted floppy disk into the floppy
disk drive and click [OK].
Installing the Operating System 4-9