NEC EXPRESS 5800 User Manual page 267
Nec electronics america server user manual
Hide thumbs
Also See for EXPRESS 5800:
- User manual (719 pages) ,
- Quick start manual (31 pages) ,
- Maintenance manual (20 pages)
Table of Contents
Advertisement
Removal
Take the following steps to remove the CPU. The EXPRESSBUILDER CD-ROM provided with
the server is necessary for confirming that the additionally installed CPU is in normal state.
Provide the CD-ROM beforehand.
IMPORTANT:
Do not remove any CPU unless it is failed.
!
Install a terminator on any slot in which a CPU is not installed.
!
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Open the top cover.
Remove the heat sink.
4.
5.
Lift the CPU socket lever to the up position (see figure below).
When you replace the CPU, install the CPU according to the steps in Installation
6.
Procedure.
When you remove the CPU and do not replace with new one, install a CPU in CPU slot
#1, and attach a terminator to CPU slot #2.
7.
Reinstall all parts removed.
Upgrading Your System 7-29
Advertisement
Table of Contents
