NEC EXPRESS 5800 User Manual page 122

3-38 Configuring Your System
Submenu item
Sync Transfer Rate
(MB/Sec)
Initiate Wide
Negotiation
Enable Disconnection
Send Start Unit
Command
Enable Write Back
Cache
BIOS Multiple LUN
Support
Include in BIOS Scan
Advanced Configuration Options
!
Move the cursor onto "Advanced Configuration Options" and press Enter to display the
following submenu.
Reset SCSI Bus at IC Initialization................................................................. Enabled
Display <Ctrl><A> Message During BIOS Initialization .................................. Enabled
Extended BIOS Translation for DOS Driver > 1 GByte ................................... Enabled
Verbose/Silent Mode...................................................................................... Verbose
Options Listed Below Have NO EFFECT if MULTI LUN Support Is
Disabled
Host Adapter BIOS ........................................................................................ Enabled
Domain Validation ......................................................................................... Enabled
Support Removable Disks Under BIOS as Fixed Disks .................................. Disabled
BIOS Support for Bootable CD-ROM.............................................................. Enabled
BIOS Support for Int13 Extensions................................................................ Enabled
Parameter Description
[160] 20.0 Select [160] as a recommended.
80.0 16.0 You may need to change the value
depending on your optional device.
53.4 13.4
Refer to the manual that comes with your
40.0 10.0
optional device.
32.0 ASYN
26.8
[Yes] Select "Yes" if your SCSI device supports the
Wide SCSI interface. Select "No" if not.
No
[Yes] Select "Yes".
No
[Yes] Select "Yes" to send the command to the
hard disk. Otherwise select "No".
No
Yes Select "N/C".
No
[N/C]
Yes Select "No".
[No]
[Yes] Select "Yes".
No
Advanced Configuration Options
[ ]: Factory-set