NEC EXPRESS 5800 User Manual page 113

Exit
Move the cursor onto "Exit" to display the Exit menu.
The following describes each option on the Exit menu:
Exit Saving Changes
!
Select this option to save the current configuration data into the CMOS (non-volatile
memory) and exit the SETUP utility.
Select "Yes" to save the current configuration data into the CMOS (non-volatile memory)
and exit the SETUP utility. The server will automatically restart the system.
Exit Discarding Changes
!
Select this option to discard the current configuration data and exit the SETUP utility.
Select "Yes" to discard the current configuration data and exit the SETUP utility, and
restart the server automatically. Select "No" to return to Exit menu.
Load Setup Defaults
!
Select this option to resume all default values (BIOS default values) of the SETUP utility.
Select "Yes" to resume default values. Select "No" to return to the Exit menu screen. If
you resumed the default values, you need to change settings as described below to
operate the system normally.
[Advanced] - [Peripheral Configuration] - [Legacy USB Support] - [Disabled]
!
[Boot] - [Boot Device Priority] - [ATPI CD-ROM Drive] - [1st Boot Device]
!
[Boot] - [Boot Device Priority] - [Removable Drive] - [2nd Boot Device]
!
[Boot] - [Hard Disk] and set the boot priority.
!
Configuring Your System 3-29