NEC EXPRESS 5800 User Manual page 274

7-36 Upgrading Your System
9. Install the components you removed previously.
10. Verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 6.
11. Select "Yes" for [Advanced]
This setting is required to change the hardware configuration data. See Chapter 3 for
details.
12. Start the BIOS configuration utility in the installed card, and set up the card.
Presence/absence of the utility and the start and operation methods depend on the card.
For details, see the manual provided with the card. If a PCI board (e.g., a disk array
controller, SCSI controller, or LAN card) with a bootable device connected is
additionally installed, the boot priority is changed to the default. After the additional
installation, start the BIOS setup utility, select [Boot]
the new boot priority. (See Chapter 3.)
Removal
Remove a PCI board in reverse order of the installation steps. After the removal, start the BIOS
setup utility, select [Boot]
3.)
[Reset Config Data].
[Boot Device Priority], and set the new boot priority. (See Chapter
[Boot Device Priority], and set