Standard Features - NEC EXPRESS 5800 User Manual

1-14 System Overview

STANDARD FEATURES

High performance
! Intel Pentium III Processor
(1GHz/1.26GHz-S)
! High-speed 100BASE-TX/10BASE-T
interface (100Mbps/10Mbps supported)
! High-speed disk access
(Ultra160 SCSI x 2)
! High-speed memory access (133MHz,
ECC, registered, PC/133 compliant, 72-
bit, 68-pin, 3.3V)
High-reliability
! Memory monitoring feature (1-bit error
correction/ 2-bit error detection)
! CPU/memory degradation feature (logical
isolation of a failed device)
! Bus parity error detection
! Temperature detection
! Error notification
! Internal fan monitoring feature
! Internal voltage monitoring feature
! Auto-rebuild feature (optional, hot-
swappable)
! BIOS password feature
! Mechanical security lock
Management Utilities
! ESMPRO
! Management Workstation Application
(MWA)
Maintenance Features
! Off-line Maintenance Utility
! Memory dump feature using the DUMP
switch
Expandability
! Two PCI add-in card slots (full-length,
full-height 64-bit/66-MHz and low-profile
64-bit/66-MHz)
! Up to 6 GB of memory
! Three hot-swap SCSI hard disk drive
bays
! Up to two multi-processors are available
for upgrade.
! USB interface (USB-support driver is
required.)
! Two network ports
Many Available Features
! Graphic accelerator "RAGE XL" support
! El Torito Bootable CD-ROM (no
emulation mode) format support
! POWER switch mask
! Software power-off
! Remote power-on feature
! AC-LINK feature
! Baseboard Management Controller
(BMC)
! Consoleless feature
Self-diagnosis
! Power On Self-Test (POST)
! Test and Diagnosis (T&D)
Easy and Fine Setup
! EXPRESSBUILDER (system setup
utility)
! Configuration Parameter Diskette Creator
! SETUP (BIOS setup utility)
! SCSISelect (SCSI device utility)