NEC EXPRESS 5800 User Manual page 245

5. Remove the four screws that hold the air baffle to the tray and remove the air baffle. Save
the air baffle for future use.
6. Remove the hard disk drive from its protective wrapper and place it on an antistatic
surface. Record the drive model and serial number in the equipment log.
7. Set any drive jumpers or switches before you install the drive. See the documentation that
comes with the device for jumper or switch information.
Place the drive into the drive tray removed in steps 3 and 4 above. Orient the drive so that
8.
its component side is down and its data connector is facing the rear of the tray. The
connector should be flush with the rear of the tray.
NOTE: If the drive comes with drive rails, do not use them. Remove any
rails already attached.
9. Using the four screws removed earlier, attach the tray to the drive.
D
A
C
A Air baffle
B
Screws (4)
C
Drive carrier
C
A Hard disk drive
B Drive carrier
C Positioning rail
D Screws (4)
Upgrading Your System 7-7
B
A
B