Rear View - NEC EXPRESS 5800 User Manual

Rear View

2
1
1 USB connector
Connect a device compliant USB interface to this connector. (Windows NT 4.0 requires a
compliant driver.)
2 Low-profile PCI board extension slot
Mount a low-profile PCI board into this slot. The slot number is 1C.
3 Monitor connector
Connect a monitor display unit to this connector.
4 SCSI connector
Connect an external SCSI device to this connector.
5 100BASE-TX/10BASE-T connectors
Connect LAN network systems to these connectors.
The number "1" following bold-faced number 5 indicates LAN port 1, and the number "2"
indicates LAN port 2.
To remove a connector in LAN port 1 use a flat-tip screwdriver to push the locking tab on the
connector. Use care not to damage the LAN port or any other ports with screwdriver.
6 LINK/ACT lamp (green)
This lamp indicates access status of the LAN.
7 Speed lamp (amber)
This lamp indicates the transmission speed of the LAN.
8 Mouse/keyboard connector
Connect the mouse and keyboard to the connector using the PS2 "Y" cable.
9 Rear serial port 2 connector
Connect a serial interface device to this connector. The server setting needs to be changed
depending on the device to be connected. This connector is capped to prevent accidentally
connecting a RJ-45 network cable connector to this serial port connector.
10 Full-height PCI board extension slots
Mount a full-height PCI board in this slot. The slot number is 1B.
6
3 4 8 9
7
5-2
5-1
10
7
12
1 11 13
System Overview 1-5
14