Hold the rail assembly and secure the front of the rail assembly with one screw and the
2.
rear of the rail assembly with two screws, while holding the rail assembly.
Screw
Used to support the set
screw of the server
Confirm that the rail assemblies are located at the level.
NOTE:
Secure the rear of the assembly after adjusting the depth of the rack and length of the rail
assembly.
Install another rail assembly on the rack in the same way as described in steps 1 and 2
3.
above.
NOTE: Confirm that the rail assembly is installed at the same level as that
of the rail assembly already installed.
FRONT
REAR
Setting Up Your System 2-11