Problems With Configuration Diskette Creator - NEC EXPRESS 5800 User Manual

Problems with Configuration Diskette Creator

<Common to Windows 2000/Windows NT 4.0>
The bit map of the Configuration Diskette Creator window is not displayed
correctly during setting of setup information.
If the specified number of colors is fewer than 256 in the display setting, the bit map is
!
not displayed correctly, but the setup information can be displayed correctly.
<Windows 2000>
The Point to Point tunneling protocol cannot be set.
The protocol is not supported at present. After installation, set the protocol through
!
Control Panel. In this case, rebooting is not necessary.
The details of a network adapter cannot be set.
Configuration Diskette Creator is unable to set the details of network adapters. Start
!
Windows 2000, and set the details through Control Panel.
<Windows NT 4.0>
Resolution cannot be set during setting of setup information.
When completing installation of Windows NT 4.0, set resolution through Control Panel.
!
More than one network board is connected during setting of setup information,
but TCP/IP cannot be set for each network.
Perform the installation procedure during DHCP setting. To create a temporary IP
!
configuration, perform the installation procedure during DHCP setting, and then set
TCP/IP again through Control Panel.
Troubleshooting 6-27