NEC EXPRESS 5800 User Manual page 268

7-30 Upgrading Your System
Power on the server and start SETUP to select menus [Main]
8.
[Processor Retest]
Execute the system diagnostic program and verify its result as described in installation
9.
procedure.
10. Verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 6.
Start SETUP and select [Main]
11.
[Enabled] to clear error information of removed CPU (see Chapter 3).
When you replaced a CPU, select [Main]
L2Cache of the additional CPU are defined normally (see Chapter 3).
Select "Yes" for [Main]
12.
This setting is required to change the hardware configuration data. See Chapter 3 for
details.
[Enabled] (see Chapter 3).
[Processor Settings]
[Processor Settings]
[Processor Settings]
[Processor Retest]
[Processor Setting] to verify that the ID and
[Processor Retest].