Installation Procedure For Nec Rack Or Vendor's Rack - NEC EXPRESS 5800 User Manual

2-8 Setting Up Your System

Installation Procedure for NEC Rack or Vendor's Rack

Installation
This server can be installed in either the NEC rack or a vendor's rack. The following procedure
describes hoe to install the server in the rack:
IMPORTANT:
provide with the cable arm assembly.
Removing the Rail Assemblies
Remove the sliding rails from the server.
1.
Hold the rails and slowly slide them toward the rear of the server until a "click" is heard.
2.
The click indicates that the rails are locked.
Push the release levers on the right and left sides of the server, and remove the rail
3.
assemblies from the server while unlocking.
Release lever
Only the inner rails remain screwed to the server when the rail assemblies have been
removed.
IMPORTANT:
rails later. To install each rail assembly on the correct inner rail, make a
mark on the assemblies. Similarly, when installing more than one server,
distinguish between the pairs of inner rails and rail assemblies of the
servers by making marks.
When installing the cable arm, see the instruction manual
The removed rail assemblies will be installed on the inner
Inner rail