Sco Openserver 5.0.6; Required Diskettes - NEC EXPRESS 5800 User Manual

4-46 Installing the Operating System

SCO OPENSERVER 5.0.6

This chapter contains supplemental instructions needed to install and configure
hardware and software used with the Santa Cruz Operation (SCO) Network Operating
System OpenServer Release 5.0.6. This information is intended to supplement the
more detailed procedural documents available from Santa Cruz Operation. This
information is not intended to be the central source of installation and configuration
information for SCO OpenServer on your system.
Note: Read the System Release Notes for the latest system
information before attempting to install SCO OpenServer on your
system.

Required Diskettes

Note:
card are generated from the EXPRESSBUILDER CD shipped with
the system.
Depending upon the hardware complement in your system, you may require some or
all of the diskettes listed in the table below. They should be generated before
attempting to install the operating system. Also listed in the table below are the
required diskette labels.
When creating the required diskettes from the
EXPRESSBUILDER CD make sure you use the drivers required
for the devices on your specific system.
Always read the information in the release notes or inserts,
included with any options for they supersede the information in this
guide.
Device
NEC SecuRAID 112 (Mylex AcceleRAID 160)
NEC SecuRAID 320 (Mylex AcceleRAID 352)
Adaptec 7899 Onboard Controller
Intel PRO/100+
1
Generated from the EXPRESSBUILDER CD.
2
Required only if RAID controller card is installed.
Diskettes for the PCI LAN cards and RAID adapter
! CAUTION
™
LAN Card
1
Required Diskette
Mylex AcceleRAID 160/352 Drivers
for SCO OpenServer
Adaptec Ultra 160 Drivers for SCO
OpenServer
Intel PRO/100+ Driver for SCO
OpenServer 5.0.X
2