Top Of Form - OKIDATA ML590 Service Manual

3.3.05 Top of Form

General Information
Top of Form is the distance from the top edge of the paper to the first print position on the page.
The red line on the ribbon protector indicates the baseline of the Top of Form.
Setting Top of Form
1. Deselect the printer. The
TOF
2. To set the further down the page, press and hold the
FF/LOAD
switch. This will advance the paper in micro increments.
TOF
3. To set the higher on the page, press and hold the
switch. This will retract the paper in micro increments.
4. This setting will be kept in memory until you power off the printer or until you change the
setting.
5. To maintain this setting in the printer's memory (even when the printer is powered off), press
and hold the SHIFT switch while pressing the
6. Press the SEL switch.
Reset the Top of Form to Factory Default
1. Power off the printer.
2. Press and hold the
NOTE:
The factory default Top of Form Setting is 1 inch.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
SEL
lamp must not be lit.
QUIET and FF/LOAD
Service Guide ML590/ML591
Chapter 3 Maintenance & Disassembly
SHIFT
SHIFT
switch while pressing the
QUIET/TOF switch.
switches while you power on the printer.
switch while pressing the
Page: 132
LF