Paper Feed Monitoring; 2'Nd Tray Communication Error; Cover Open - OKIDATA OKIFAX 5700 Maintenance Manual

B.3.2.3

Paper Feed Monitoring

Status
Paper supply error
Transport system jam 1
Transport system jam 2
Transport system jam 3
Paper size error
Paper outlet jam 1
Paper outlet jam 2
B.3.2.4

2'nd Tray Communication Error

This error is generated if on sending a command to the 2'nd tray is returned no-status
(90 ms) or an undefined status. However, in case there is no status when reset, it will be
considered that the 2'nd tray is not mounted.
B.3.2.5

Cover Open

Cover open sensor "0" indicates an open cover.
When the cover is closed the CU (control unit) section sends the reset signal and pro-
cesses in the same way as if the power has been turned on.
OKIFAX 5700/5900
Description and Supervising Sensor
Indicates monitoring error in hopping.
Hopping is retried 3 times.
Indicates an error in the paper transport path.
Error on resist roller section.
From resist ON to write sensor (PS2) ON.
From inlet sensor OFF up to write sensor OFF.
Indicates an error in the paper transport system.
Error of transfer roller and/or heat roller.
From write sensor ON to outlet sensor ON.
Indicates paper size other than specified one.
From resist ON to inlet sensor OFF.
Supervises slipping of the recording paper.
From outlet sensor ON to OFF.
Supervises jamming at the near paper outlet.
From outlet sensor ON to OFF.
When a crumpled recording paper is detected,
the outlet sensor is set to "OFF" earlier than usual.
B - 15
DESCRIPTION OF
PRINT OPERATIONS
Distance
118 mm or less path
Length +36 (hopping) x 3
30 mm or less
Inlet ~ write +20
44 mm or less
207 mm or less
Write ~ outlet +69
Recording paper +/- 45 mm
Recording paper +/- 45 mm
135 mm or less: NG