Table of Contents
Advertisement
TABLE 3-4. VOLTAGE AND CURRENT PARAMETER DEFINITIONS (CONTINUED)
Term
Minimum (box)
Current mode only. Minimum (positive) setting for +Voltage Protect and
+Voltage Protect Min
maximum (maximum negative) setting for –Voltage Protect. Values of ±Volt-
–Voltage Protect Max
age Protect between +Voltage Protect Min and –Voltage Protect Max (near
zero) are not allowed. This zone (also referred to as the minimum (box) is
automatically calculated by the BOP (see Figure 1-3).
+Current
Current mode only. Positive and negative output current established by
–Current
keypad or remote command.
Range (+): 0 to +Current max
Range (–): 0 to –Current min
+Current max
Current mode only. Maximum (positive) and minimum (maximum
–Current min
negative) current that can be set.
Value (+): 0 to +I
Value (–): 0 to –I
%
Press
from the power-up screen to enter the General Setup menu (Figure 3-6), then high-
light Max/Min Settings. Press
Password is required, see PAR. 3.2.4.4 for instructions.) Highlight Protect Entry and press
change it. Highlight Bipolar or Independent, then
$
press
to save for power-up, or
power-up) and exit.
3-14
Definition
Onom
Onom
!
to enter the Max/Min Settings submenu (Figure 3-7). (If a
#
to abort, or
FIGURE 3-6.
GENERAL SETUP MENU
$
%
to save, or
to abort. When complete,
%
to apply the changes (without saving for
To modify
refer to PAR.
Local
Remote
N/A
N/A
3.3.3
B.17
3.3.4.1
B.19, B.20,
B.23, B.21
!
to
BOP HIPWR 080709
Advertisement
Table of Contents
