Miscellaneous Features - KEPCO BOP 1000W Operator's Manual

High power bipolar power supply
Hide thumbs Also See for BOP 1000W:
Table of Contents

Advertisement

SPECIFICATION
SAVE/RECALL CHARACTERISTICS
Number of Locations
Parameters Saved or Recalled
Mode of operation
Protection Limit Amplitude

MISCELLANEOUS FEATURES

Maximum/Minimum Settings
Protection Limit Channel
(maximum value, Internal)
Load Type Settings
Self-test capabilities
Interface Settings
Output Status @ Reset
Calibration
1-8
TABLE 1-2. BOP GENERAL SPECIFICATIONS (Continued)
RATING/DESCRIPTION
(See PAR. 3.3.8)
Voltage, Current or External
Reference type
Internal, External or
External Reference Level
Internal, External or
Main Amplitude
0 to E O
(Internal)
(internal or external)
E O
(Internal)
1.01 E O
Output status
Protection Limit
Bipolar (default) or Independent
Type
Main Channel
0 to E O
E O
1.01 E O
Active (default), Resistive,
Display, Keypad, Interface, Serial
Interface, Analog, Output
Data Format
SCPI (default), CIIL
GPIB Address
0 to 30 (6 = default)
ON or OFF (OFF = default)
Serial Baud Rate
Off, 9600, 19200 (Off = default)
Device Clear
SCPI (default) or MATE
XON/XOFF
Enable (default) or Disable
Prompt
Disable (default), Enable,
Assisted by front-panel prompts
99
Lesser Limit
or I O
NOM
NOM
or I O
to
MIN
MIN
or I O
NOM
NOM
ON or OFF
or I O
(default)
NOM
NOM
or I O
to
MIN
MIN
or I O
(internal)
NOM
NOM
Battery, Custom
Enable with Echo
RATING/DESCRIPTION
All parameters saved for power-up.
For External the operating mode is deter-
mined by signal at I/O Port; no signal selects
voltage mode (see PAR. 3.4.2).
Main channel
Limit channel
Main Channel:
Voltage (Volts) for Voltage mode,
Current (Amperes) for Current mode
Limit Channel, Positive and Negative
Voltage (Volts) for Current mode,
Current (Amperes) for Voltage mode
Software limit to setting of main channel
Voltage (Volts) for Voltage mode,
Current (Amperes) for Current mode
Software limit to setting of protection limit
channel.
Voltage (Volts) for Current mode
Current (Amperes) for Voltage mode
Consult factory for custom setting.
Serial Interface test requires Loop Back Test
connector (p/o KIT 219-0436, see Table 1-5).
BOP HIPWR 080709

Advertisement

Table of Contents
loading

Table of Contents