Table of Contents
Advertisement
To change the background, press
!
, highlight Black or White, then
apply the changes (without saving for power-up) and exit.
TABLE 3-3. DISPLAY (OPERATOR CONVENIENCE) MENU FUNCTIONS
SETTING
(BOLD = Factory Default)
NOTE: To save any of the functions listed below for power-up it is necessary to first change SAVE DISPLAY CHG at the password
setup (see PAR. 3.2.4.3and Figure 3-5) from DISABLE to ENABLE.
GRAPHIC DISPLAY
DISPLAY
BACKGROUND
REMOTE
DEBUG
KEY PRESS BEEP
NOTE: Control display contrast by pressing
acceptable. Contrast can also be set directly by pressing
3.2.5.2
DISPLAYING PROGRAMMED SETTINGS IN REMOTE MODE
When Remote Debug is set to OFF (default), the programmed settings for main and protection
channels that are displayed on the LCD in local mode, are not displayed while in remote mode
and the LCD reads "Display settings off." When set to ON, the programmed settings for main
and protection channels are displayed, however the unit responds more slowly in remote mode.
To change the Remote Debug setting, press
light Remote Settings, press
for power-up or
3.2.5.3
ENABLING/DISABLING AUDIBLE BEEPS
From the power-up screen (Figure 3-3), press
using the techniques described in PAR. 3.2.4). Even though audible beeps are set to off, the
beeps will still sound upon power-up or detection of a power supply fault.
3-10
#
$
CHOICES
Meters
METERS - Output voltage and current are displayed on representations of ana-
75s Graph
log meters.
30s Graph
GRAPH - Displays a sample of the output for the time indicated (see Figure 3-
15s Graph
4). The complete time-line uses 240 points. E.g., selecting 2 Second Graph
7.5s Graph
means that 2S/240 = 50ms sampling, i.e., every 50ms a snapshot of the output
3.8s Graph
state is used to produce a single point.
1.5s Graph
0.8s Graph
0.5s Graph
0.3s Graph
0.15s Graph
0.04s Graph
0.08s Graph
White
WHITE - Sets the background to white and displays black characters.
Black
BLACK - Sets the background to black and displays white characters.
OFF
OFF - LCD does not show programmed settings for main and protection chan-
ON
nels while in remote mode of operation (local mode is unaffected).
ON - Programmed settings for main and protection channels are displayed,
however the unit responds more slowly.
ON
ON - provides an audible beep for each key press and for each error received.
ERROR ONLY
ERROR ONLY - silences the beeps for each key press; errors will still cause
OFF
beep.
OFF - silences all beeps including key presses and errors except for power-up
and unit faults.
#
twice to dynamically change the contrast, then press
!
, highlight On or Off, then
%
to apply the changes (without saving for power-up) and exit.
from the power-up screen, Highlight Background, press
$
to save. Press
exit and save for power-up or
FUNCTION
#
T
once and using
#
from the power-up screen (Figure 3-3), High-
$
#
, then refer to Table 3-3 and modify the setting
#
to set when contrast is
R
and
as needed (see PAR. 3.2.5.1).
$
to save. Press
exit and save
BOP HIPWR 080709
%
to
Advertisement
Table of Contents
