Table of Contents
Advertisement
2.8.5
RESTORING A UNIT TO STANDALONE OPERATION
1. Turn off power to the master.
2. Turn off power to the slave(s).
3. Turn on power to the unit to be restored to standalone operation.
4. From the power-up screen press
Parallel and press
enter ADMIN2 password (see PAR. 3.2.4.4) before continuing.
@
5. Press
$
6. Press
7. Turn off power to the unit, then turn power on. The unit will power up as a standalone unit.
2.8.6
CHANGING MULTIPLE UNIT CONFIGURATIONS
To change a unit from series, parallel, Master 2X2 or Master 3X2 operation to a different config-
uration, first set the unit to Standalone by referring to PAR. 2.8.5, then refer to PAR. 2.8.3 and
configure as desired.
2-24
!
to view the Multiple Units menu (see Table 2-12). When prompted,
to return to factory defaults. This configures the unit as a standalone unit.
to save for power-up.
%
to enter the General Setup Menu. Highlight Series/
BOP HIPWR 080709
Advertisement
Table of Contents
